> ## Documentation Index
> Fetch the complete documentation index at: https://www.seam.co/docs/llms.txt
> Use this file to discover all available pages before exploring further.

# Tado Setup Guide

> Connect your Tado thermostats to Seam. Approve Seam in your Tado account through the Connect Webview, then verify that your rooms appear as thermostats.

## Overview

This guide walks you through connecting your Tado account to Seam. Your Tado devices must already be set up and visible in the Tado app before you begin. Seam supports the Tado V3 and V3+ range. Tado X devices aren't supported.

You don't enter your Tado password in the Connect Webview. Instead, you sign in on Tado's own website and approve Seam there.

***

## Step 1: Check Your Tado Account

1. Sign in to the Tado app with the account that you want to connect.
2. Confirm that the rooms you want to control appear in the app and that their devices are online.

Seam connects every Tado home that this account can access. Each heating room and each Smart AC Control room becomes one thermostat in Seam. Hot water rooms don't appear in Seam.

***

## Step 2: Approve Seam in Tado

1. Open the [Connect Webview](https://www.seam.co/docs/core-concepts/connect-webviews.md) provided by your application.
2. Select **Tado** as the provider.
3. Select **Open tado**. Tado's sign-in page opens in a new tab. If the link doesn't open, copy the web address shown in the Connect Webview into a browser on any device, such as your phone.
4. Sign in to Tado, and check that Tado shows the same code as the Connect Webview.
5. Approve Seam in Tado.
6. Return to the Connect Webview. It continues on its own within a few seconds. You can also select **I've approved Seam in tado**.

The approval link expires after a few minutes. If it expires, the Connect Webview shows a new link. Approve Seam with the new link.

***

## Step 3: Verify the Connection

After you connect, check that your Tado rooms appear as thermostats and show as online. A heating room supports heating and off. A Smart AC Control room supports cooling and off, and also heating if the air conditioner has a heat mode.

Room temperatures and settings can take up to an hour to update after a change in the Tado app, because Tado doesn't send updates to Seam as they happen.

***

## Troubleshooting

### The approval link expired or the request was declined

The Connect Webview shows a new link and a message. Select the new link and approve Seam in Tado again.

### Tado hasn't confirmed the approval

If the Connect Webview says that Tado hasn't confirmed yet, make sure that you approved Seam in Tado, not only signed in. Then, select **I've approved Seam in tado** again.

### Rooms not appearing after authorization

* Make sure you approved Seam with the Tado account that has access to the home.
* Check that the room's devices are online in the Tado app.
* Hot water rooms and Tado X devices don't appear in Seam.

### A thermostat shows as offline

Seam shows a room as offline when Tado reports that the room's devices have lost their connection, such as when the Tado Internet Bridge is offline. Check the room's devices and the Internet Bridge in the Tado app.

### The connection stops working

If you remove Seam's access in your Tado account, or Tado stops accepting it, the connected account in Seam reports an error. Reconnect your Tado account through a new Connect Webview.


This documentation is built and hosted on [Mintlify](https://mintlify.com), a developer documentation platform.